Products > Acupuncture & Moxibustion Supplies > Point Detectors, Detectors with Stimulation & Acupuncture Stimulators



ED3928
TENS 2000 - Transcutaneous Electrical Nerve Stimulator

Q.O.R.


-
The Transcutaneous Electrical Nerve Stimulation System which is used for the symptomatic relief and management of chronic intractable pain and as an adjunctive treatment in the management of post-surgical and post-traumatic acute pain problems. Effectiveness is dependent upon patient selection. Transcutaneous Electrical Nerve Stimulation delivers most stimulation to the surface of the skin directly under the electrode. It uses discrete electrical impulses delivered at low frequencies.

Specification:
Channels : Four
Output Voltage : 0 - 100 Volt (Open Circuit)
Intensity (Output Current) : 0 - 80 mA on 500 Ohm Load
Pulse Rate : 1 - 200 Hz (adjustable)
Pulse Width : 50 - 300 μS (adjustable)
Output Modes - Mode OFF (OFF) : Switch OFF Mode
- Brust (B) : 1.2 Second per Burst "ON"
: 1.2 Seconf per Burst "OFF"
- Constant (C) : Regular Output
- Modulation (M) : Pulse Width Modulation, 100 - 300 μS/1.2 Second
Pulse Shapes - Asymmetric (ASY) : Asymmetric modified rectangular
- Symmetric (SY) : Symmetric modified rectangular
- D. Symmetric 1 : Symmetric modified rectangular
(DSY 1) : 1 Second Consists 11,000 Hz base impulse
- D. Symmetric 2 : Symmetric modified rectangular
(DSY 2) : 1 Second Consists 32,000 Hz base impulse
DC Power Jack : 6.3 mm x 2 mm Centre Pin
Power Source : 6 pcs. of 1.5V (LR6) Batteries or DC 9V Adaptor
Output Socket : 1.5 mm Diameter Socket
Unit Dimensions : 160 mm x 90 mm x 50 mm
Weight of the Unit : 250 g
Operation Temperature : 0 ℃ to 35 ℃
Operation Humidity : 90% RH maximum
Storage Temperature : -20 ℃ to 50 ℃
Tolerances : +/-10%

Output Parameters are across a 500 ohm resistance.






Copyright 2014. Mayfair Medical Supplies Ltd. All Rights Reserved.